It's impossible to type Polish letters in the usual way: lowercase "ć" (right Alt+C) and uppercase "Ź" (right Alt+Shift+X).
This is likely due to SoftMaker Office NX misinterpreting the codes for these key combinations received from Windows because:
- The "Tools / Unicode to Hex Value" command has the shortcut Alt+Ctrl+Shift+X, and pressing the combination (right Alt+Shift+X)
doesn't display the uppercase "Ź" but executes the above command.
- The "Format / Copy Formatting" command has the shortcut Alt+Ctrl+Shift+C, and pressing the combination (right Alt+Shift+C)
doesn't display the lowercase "ć" but executes the above command.
The same applies in TextMaker and Presentations, but only for the Alt+Ctrl+Shift+X shortcut.
You can change these shortcuts, but not everyone will figure it out, and the first impression will be that the program
is not working properly.
Polish letters "ć" and "Ź"
Re: Polish letters "ć" and "Ź"
Thank you for the detailed report and for tracing it back to the shortcut assignments. I can reproduce this issue.
As an immediate remedy, the two shortcuts can be cleared or reassigned under Tools > Customize > Search for "Copy formatting" and "Unicode to Hex value"> remove these shortcut keys, after which both letters are entered as expected.
I agree that this should not require manual intervention, and I have forwarded the report.
As an immediate remedy, the two shortcuts can be cleared or reassigned under Tools > Customize > Search for "Copy formatting" and "Unicode to Hex value"> remove these shortcut keys, after which both letters are entered as expected.
I agree that this should not require manual intervention, and I have forwarded the report.
Re: Polish letters "ć" and "Ź"
Our developer team has fixed this issue for the next service pack.
